HELPPP!! We're trying to load music already recorded on Yamaha CVP401 through audio gram 6, CubaseAI 4 software. Cannot find USB Audio driver. It's only recording through microphone. klewrogers

You can download the Audiogram driver at this link:

http://www.yamahasynth.com/downloads/drivers_software/interfaces/audiogram/driver/

After installing the driver, open Cubase and go to Devices - Device Setup - VST Audio System and switch to the Yamaha USB Audio driver for the Audiogram.

Thanks. It's now recording but I can't hear anything on the playback.

After you record the audio, be sure to turn off the Record button and the the Monitor button on the audio track.

It's not recording from the piano again. We downloaded the software, it worked once, we went back tonight to try it again and can't get it to record at all. Can someone walk us through each step??? This is really, really frustrating. Yamaha said this could be done.

First, go to devices and VST Connections. Select the Input section and make sure that the bus for your keyboard is assigned to the correct inputs in the Device Port Column.

Now go to the audio track and make sure that the right input bus is selected in the inspector column. Be sure to select the Record Enable button and Monitor button on the track.

You should get an audio signal at that point.

Thanks. We just need to get it into an mp3 format or something other than cpr.

Any advice on getting the recordings into an mp3 format?

We've got it. Thank you for your help.

Bought the Firestudio Project and loaded the cubase le4 on my G4. Never worked. Could never get sounds from microphone or MIDI into my computer. Bought a new MacPro. Tried to change the software over. A nightmare. Access codes NEVER worked and I now have software and an expensive piece of equipment that simply DO NOT work. Company support is atrocious. Manual is even worse. Anyone have any help out there. Pretty frustrated that this equipment isn't a bit intuitive.

Jim