rene
Newbie
Reged: 08/18/08
Posts: 4
|
|
i want to know if it is possible to set up my esx1 with cubase studio 4 via the generic remote or quick controls or any other way....optimally i would like to use the control knobs and parameters as they exist in esx1 on cubase...
|
mashedmitten
Regular
Reged: 05/05/08
Posts: 184
|
|
For the Generic Remote, select the device, hit learn, move a control and assign a parameter.
|
rene
Newbie
Reged: 08/18/08
Posts: 4
|
|
that doesnt seem to work....the values on the generic remote table dont change
|
mashedmitten
Regular
Reged: 05/05/08
Posts: 184
|
|
Then you're doing something wrong. Don't edit an existing line, add new ones. I delete all of the lines that show by default before I start entering my own.
Edited by mashedmitten (08/19/08 09:39 AM)
|
ChrisDobbs
Guru
Reged: 05/31/05
Posts: 1078
Loc: Indy
|
|
Hello,
Personally I like using the Quick Controls. I think they are much easier to setup and modify.
1. Setup your knobs to control QC. Go to Devices, Device Setup, Quick Controls. Here you can setup using Midi Learn each of the knobs you want to use. Set the input and output port to your keyboard.
Click Learn and turn the knob you want to use for each parameter.
2. In the project (or in your template), setup the parameters that you want each QC to control. Personally I just wait until I have something I need to control (Send 1 Level), and then add it to the track.
The operation manual discusses QC starting on page 312. I hope this helps.
--------------------
Chris Dobbs
Steinberg Support
www.steinberg.net
www.steinbergupgrades.com
|
Previous
Index
Next
Threaded
Edit
Reply
Quote
