lucho
Freshman
Reged: 01/17/07
Posts: 45
Loc: 02215
|
|
hey gang, what is this in the infoline that say offset?... i dont know what is going on but when I'm trying to cut measures of an audio file the files are not cut and the bar-line, even if I have Quantize set to bar!! the have like an offset and i find out in the info line for the audio files that say: offset, and this parameter it is not actually in the Operation Manual, there is a list of things that may appear in the infoline but this is not there!.. I'm gonna search for some manual update, this is really bad issue i need to solve, and hey!!.. hey!!.. nobody answers me back the previous comment about the MIDI issue!!.. pleas guys, I'm working my us behind this wheal and i go crazy if I cant get the answer!!.. help!! .. Nuendo 4.1.3 Build 853 Mac Intel
|
ChrisDobbs
Guru
Reged: 05/31/05
Posts: 1069
Loc: Indy
|
|
Hello,
The offset shows you how much of the start of the file is not being shown. When you edit a wave file you should see a change in the offset. Do you have the snap control turned on or off? Thank you.
--------------------
Chris Dobbs
Steinberg Support
www.steinberg.net
www.steinbergupgrades.com
|
lucho
Freshman
Reged: 01/17/07
Posts: 45
Loc: 02215
|
|
may the i was in Snap off mode but i don't actually remember, i will be doing some editing next week so if i get blocked again i'll let you know what's wrong!!.. thanks!!
|
lucho
Freshman
Reged: 01/17/07
Posts: 45
Loc: 02215
|
|
ok Chris, here I'm back in this issue and i clearly find out what the problem was!.. i was actually working in snap mode on, but also in Snap to Zero Crossing too!.. so when i was trying to cut and the beginning of the measure the system performed the cut in the closer Zero crossing point i attach a photo of the example so you can see!! not big issue but i was really frustrated for some minutes!!
|
Previous
Index
Next
Threaded
Edit
Reply
Quote
